XYplorer Beta Club

Would like this ON by default. Is this possible? I looked for a config setting and could not find one.

Tools > Customize List > Checkbox Selection.

There's also a toolbar button available.

After you enable the checkbox selection, save your default folder view.

View > Folder View Setting > Define this folder view as default

Tick this: Configuration | Styles | Apply list styles globally

Then turn checkbox selection on.

nerdweed wrote:After you enable the checkbox selection, save your default folder view.

View > Folder View Setting > Define this folder view as default

This worked, thanks.

FVS is total overkill here. Style settings are remembered by default anyway.

admin wrote:FVS is total overkill here. Style settings are remembered by default anyway.

Not in my case. When I set checkbox on for a folder, it was only on for that folder. Other folders had checkbox off. I had to use FVS to make it permanent for all folders.

.

mwoffenden wrote:

admin wrote:FVS is total overkill here. Style settings are remembered by default anyway.

Not in my case. When I set checkbox on for a folder, it was only on for that folder. Other folders had checkbox off.

That can only be the case if you already use a default FVS without checkboxes for all folders.

Thanks for everyone's comments. I think everyone is correct based on where they are coming from and the configuration they are using.

However, at the end of the day, the only thing that worked for in my situation, as mentioned, is using FVS to make it permanent for all folders.

Weird.

So let me finally stress that checkbox selection works out of the box with nothing more than a single click as described here: http://www.xyplorer.com/release_13.10.htm. For all tabs, in all panes, in all OS, without any need for FVS or any other heavy feature.

Hi Don,

admin wrote:For all tabs, in all panes, in all OS, without any need for FVS or any other heavy feature.

I experienced the same FVS-dependency as mwoffenden. And with 13.10.0003 it's still unchanged.

When I activate it via Tools | Customize List | Checkbox Selection the check box is displayed in the current list, but changing to a different folder immediately makes it gone. Even going back to the previous list doesn't make it reappear on the folder it was initially activated.

Weird, indeed.


Cheers,
Filehero

Hm, you can easily verify with a fresh install that FVS is not necessary at all.

admin wrote:Hm, you can easily verify with a fresh install that FVS is not necessary at all.

Confirmed.

And with my current setup I can make it work as expected, if I uncheck Applied Settings | List Style for the <Default>-FVS. If I check List Style again, the check boxes are gone again.


Cheers,
Filehero

That's what I already said here: http://www.xyplorer.com/xyfc/viewtopic. ... 404#p93404

Folks, believe me. No need for FVS here. The whole idea of FVS is something totally different.