X64 BETA UI will messed up when it starts with dual panel

[Prevent6048]

X64 BETA UI will messed up when it starts

I need to press F10 to toggle it to normal single panel then F10 Again to switch back to dual panel

AT LEAST IN 27.90.0022 64BIT AND OLDER

- Windows 10 64bit Version 22H2 (Build 19045.3324)

[admin]

See signature.

[Prevent6048]

See signature.

My signature updated.

[admin]

Thanks! Can't reproduce your issue though. Can you mail your XYplorer.ini file to support?

[Horst]

I always use dual pane.
For me, this error was only on the very first versions of the x64.
Never had it again.

[Prevent6048]

Thanks! Can't reproduce your issue though. Can you mail your XYplorer.ini file to support?

Please check your mail.

1. After Every restarting computer will leading this problem as my memory.

2. I have two ini file. XYplorer0421.ini and a very old XYplorer.ini, if I manually rename XYplorer0421.ini to XYplorer.ini and removed the old one. XYplorer will tell me the config is missing.

[admin]

Got it, and could reproduce it.

Why didn't you mention that you enabled "Configuration | General | Startup & Exit | Minimize to tray on X close"? Wasn't it obvious that this might be relevant here?

[admin]

Anyway, fixed in next beta.

[Prevent6048]

Got it, and could reproduce it.

Why didn't you mention that you enabled "Configuration | General | Startup & Exit | Minimize to tray on X close"? Wasn't it obvious that this might be relevant here?

I changed configrations parameters very often and don't have enough developing knowledge. And I changed from X32 VERSION TO X64 VERSION just now. Perhaps in X32 VERSION it works OK.

[admin]

Yes, x32 never had this problem. The recent x64 (v27.90.0032) should work well, too.