XYplorer Beta Club

I searched the whole forum for Expansion Icons and didn't see anyone else with my problem...

The PDF Manual says the default for folder expansion icons is to *Not* show them for a folder that has no sub-folders. When I open XYplorer, every folder shows an expansion icon - even if it has no sub solders. If I refresh the tree, then expansion icons for folders with no-subdirectories Immediately disappear. If I close and reopen Xyplorer the expansion icons for all folders return. Also, if I click on a folder expansion icon for a folder that has no sub-folders, then the expansion icon disappears.

It's not a problem for me to refresh the tree when I open XY because I have it open all the time, but the problem is that a refresh only remedies the expansion icons with folders in the root directory. All other lower level directories have the same problem until I refresh them, but that of course is not a workable solution.

I've tried all kinds of setting changes, but nothing fixes this.

I'm hoping someone might have a suggestion for me to try?

Thanks!!

Win 11 | Xyplorer 28.20.0.600 (64-bit)

XY

Below is the setting you want enabled, but the default is enabled, so you either disabled it yourself, or maybe you are on a network, in which case you would need to also enable the setting directly under it in config dialog.

Configuration | General | Tree and List | Tree | [x] Check existence of subfolders in tree

Thank you, that fixed my issue - I must have deselected that after reading the tool tip that said deselecting that would speed up browsing the tree &considerably*, but I can't really tell a difference - yet, anyway.

Thanks again!