CFI for mounted network drives doesn't work in the tree properly
Posted: 11 Dec 2025 05:17
x86/x64 both affected.
When using a CFI for a mapped network drive eg
In the GIF below you will notice the correct red white CFI icon is showing in the AB/TAB/BC, and why the icon is flashing in the tree is I am repetitively doing a "Reset Tree" to illustrate that it shows the correct icon temporarily before the wrong icon is shown again, same as if I launch XY, the correct CFI icon is shown = until I click on the drive in the tree.
I forgot to mention to repro in fresh, the default empty folder CFI entry must be enabled, as well as this:
Configuration | General | Safety Belts, Network | Network | [x] Assume that mapped network drives are available
If immediately after config changes, if the icon doesn't go to the generic network icon immediately, it may require selecting in the tree and a Shift+F4 or Ctrl+Sft+F4 then toggle to/from the drive.
So to repro, requires above setting, and the following script should setup and enable CFI in fresh if req:
When using a CFI for a mapped network drive eg
T:\><xy> then it seems to show ok in the tree, but only until you click on it, from then on I get the generic OS network drive with the green cable under it icon.In the GIF below you will notice the correct red white CFI icon is showing in the AB/TAB/BC, and why the icon is flashing in the tree is I am repetitively doing a "Reset Tree" to illustrate that it shows the correct icon temporarily before the wrong icon is shown again, same as if I launch XY, the correct CFI icon is shown = until I click on the drive in the tree.
I forgot to mention to repro in fresh, the default empty folder CFI entry must be enabled, as well as this:
Configuration | General | Safety Belts, Network | Network | [x] Assume that mapped network drives are available
If immediately after config changes, if the icon doesn't go to the generic network icon immediately, it may require selecting in the tree and a Shift+F4 or Ctrl+Sft+F4 then toggle to/from the drive.
So to repro, requires above setting, and the following script should setup and enable CFI in fresh if req:
Code: Select all
seticons("+*\ /e><xypath>\XYicon_FolderEmpty.ico<crlf>+T:\><xy>", s); #505;