XYplorer Beta Club

hi! i have a shortcut/LNK file in a folder that points to my other workstation. on occasion, this workstation is powered off. when i happen to drag a file over the shortcut (not to drop it on, just passing by, dragging from bottom of list to top, etc.), there is approximately ~15-20 second delay (blue spinning circle) until it realizes it is off, then my drag continues.

what setting do i need to adjust to allow it to pass over instantly as it does when the workstation is on (no delay when the workstation/share is on) ?

i have these already set : the workstation is also listed under :

What if you pass it over the workstation itself (not the link). Isn't it the same?

admin wrote: ↑08 Sep 2023 12:20 What if you pass it over the workstation itself (not the link). Isn't it the same?

hi! i'm not sure about this. the workstation isn't shown anywhere in my tree or list. i use the mini-tree and keep it clean so there isn't a history of it there. the only reference i have of it that i interact with is the shortcut. the shortcut just contains \\remote-workstation-name\share-name.

when the other workstation is on, i can drag over it instantly with no pause or timeout at all. if i hover it, it even shows the resolved path of the share on the remote workstation (which is pretty cool). but if that workstation is off (and i forget) and happen to be dragging show that passes over it - ~15-20 second delay.

i do a lot of dragging in the file list or between panes. i only run into delays when i pass over the shortcut if the workstation is off. i thought maybe the "Assume that servers are available" option would kick in and prevent the delay.

Okay, got it. Should be better in next beta.

fixed in v24.90.0116 - 2023-09-10 11:08 ! updated and tried it out and it worked perfectly ! there is now NO DELAY when dragging over the shortcut and the other workstation is offline.

thank you !