Page 1 of 1

Can't set the CreateJunctionPrefix to nothing

Posted: 15 Mar 2013 13:01
by lukescammell
I can't seem to set the CreateJunctionPrefix to nothing. I can set it to a single character just fine, but setting it to nothing (see code below) means it falls back to the default "Junction to " prefix, which is a little irritating.

Code: Select all

; Tweak: 
CreateSymlinkPrefix=""
; Tweak: 
CreateJunctionPrefix=""
CreateSymlinkPrompt=0
CreateJunctionPrompt=0
Is there another tweak I am missing that will make this work?

Thanks ;)

Code: Select all

v11.90.0104 - 2013-01-05 18:03
    * The following tweaks have to be reset to "" on upgrading and will 
      then internally default to the values shown here:
        CreateSymlinkPrefix="SymLink to "
        CreateJunctionPrefix="Junction to "
      If you want other values you have to re-tweak (but these tweaks 
      will not be covered by MLS of course, IOW they will stay in the 
      language you have chosen for them).