Page 1 of 1

Refreshing tree and list

Posted: 08 Mar 2013 22:10
by Borut
It is my understanding that:

F5 should refresh both list and tree
F4 should refresh only tree
Ctrl+F5 should refresh only list

For a very long time it seems to me that F5 is refreshing only the list. If I do both F4 and F5, then I get what I would actually expect from F5. (Until recently I had other shortkeys attached to these functions, but today I reverted to these defaults (hopefully I got it correctly)).

I ever wonted to know what's up with this, but was afraid to ask. :roll: Even now it is hard to imagine that the problem by such an important function could be in XYplorer and not at my side.

I am noticing this when... I am positioned, say, in a directory A. Another application creates a subdirectory AA. This I see in the list as it happens (Auto-refresh ON; Refresh during file operations ON). Nothing new to be seen in tree (I believe that this is probably as expected).

When I now press F5, still nothing new is to be seen in the tree (to my understanding this is NOT as expected). However, if I press F4, the new subdirectory becomes visible in tree (as expected).

What am I doing (or expecting) wrong?

Re: Refreshing tree and list

Posted: 10 Mar 2013 12:50
by RalphM
No, F5 = Refresh List and F4 = Refresh Tree has been like that for a long time but you can easily create an UDC that does both and reassign F5 to it.
I seem to recall that this has been discussed before in the forum...

Re: Refreshing tree and list

Posted: 10 Mar 2013 14:17
by admin
Uh, no. :)

"Refresh" (F5) has always refreshed Tree and List. But on 20121208 I made a change not documented in the change log, whereby "Refresh" does NOT refresh the tree anymore when the focus in the list.

Re: Refreshing tree and list

Posted: 10 Mar 2013 16:18
by Borut
Thanks to both of you. I'll probably follow Ralph's advice.