Page 1 of 1

Problem on handling Tabset("load", name, 1)

Posted: 23 Mar 2012 15:53
by PeterH
Don't know where to post this: 1/2 bug, 1/2 question and 1/2 wish, makes 1.5 :shock:
- so here it is:

I use tabset("load", name, 1) with explicit pane number if I want to load a tabset independent from the currently active pane.
But if I see it right this command changes the active pane to pane 1?!

I would not expect that after a tabset change independent from active pane the active pane is affected. Or am I wrong?

Re: Problem on handling Tabset("load", name, 1)

Posted: 27 Apr 2012 17:57
by admin
Well, correct. Loading a tabset into a pane will activate that pane.

Re: Problem on handling Tabset("load", name, 1)

Posted: 28 Apr 2012 00:50
by PeterH
admin wrote:Well, correct. Loading a tabset into a pane will activate that pane.
Too much smartness, from my point of view. :wink:

If I want
to switch the pane and load a tabset, I can switch and then load to active pane - no pane number in tabset/load needed at all.
But now, if I load in other pane but don't want to switch, I first load and then must switch back.
(OK: I could switch, then load active, then switch again :oops: )

For me not really logical.

In real it's still more complicated: I want to load tabsets to both panes!
Wish: load tabset1 to pane 1 and load tabset2 to pane 2, ready.
But now: look/remember which pane is active, load both tabsets, and then maybe switch back to the pane that was active before :cry:

:arrow: too much smartness, as I have to "code against it".

Re: Problem on handling Tabset("load", name, 1)

Posted: 28 Apr 2012 10:08
by admin
Currently Tabsets are not on my list. I have other boxes open... :)