XYplorer Beta Club

X64 BETA UI will messed up when it starts

I need to press F10 to toggle it to normal single panel then F10 Again to switch back to dual panel

AT LEAST IN 27.90.0022 64BIT AND OLDER

- Windows 10 64bit Version 22H2 (Build 19045.3324)

See signature.

admin wrote: ↑18 Aug 2025 11:42See signature.

My signature updated.

Thanks! Can't reproduce your issue though. Can you mail your XYplorer.ini file to support?

I always use dual pane.
For me, this error was only on the very first versions of the x64.
Never had it again.

admin wrote: ↑18 Aug 2025 14:47 Thanks! Can't reproduce your issue though. Can you mail your XYplorer.ini file to support?

Please check your mail.

1. After Every restarting computer will leading this problem as my memory.

2. I have two ini file. XYplorer0421.ini and a very old XYplorer.ini, if I manually rename XYplorer0421.ini to XYplorer.ini and removed the old one. XYplorer will tell me the config is missing.

Got it, and could reproduce it.

Why didn't you mention that you enabled "Configuration | General | Startup & Exit | Minimize to tray on X close"? Wasn't it obvious that this might be relevant here?

Anyway, fixed in next beta.

admin wrote: ↑19 Aug 2025 11:39 Got it, and could reproduce it.

Why didn't you mention that you enabled "Configuration | General | Startup & Exit | Minimize to tray on X close"? Wasn't it obvious that this might be relevant here?

I changed configrations parameters very often and don't have enough developing knowledge. And I changed from X32 VERSION TO X64 VERSION just now. Perhaps in X32 VERSION it works OK.

Yes, x32 never had this problem. The recent x64 (v27.90.0032) should work well, too.