Page 1 of 1
Problem after upgrading
Posted: 23 May 2025 21:18
by nsyrax
I installed v27 on a new computer and also upgraded my license from v24. When I load the configuration from my previous version so I can have all my previous settings, it tells me my version isn't supported, as it sees my previous version, but all my settings seem in place. I add my new license, it says it was successful, and I restart XYPlorer, but it's back to the defaults of a fresh installation of v27. How do I get all my settings back?
Re: Problem after upgrading
Posted: 23 May 2025 21:37
by highend
Show the content of the Startup.ini file in the installation folder of XY?
What's the full folder path when you're using Menu - Go - Go to Application Data Folder?
Re: Problem after upgrading
Posted: 23 May 2025 22:48
by nsyrax
[Appdata]
Path=%appdata%\XYplorer
C:\Users\nic.syax\AppData\Roaming\XYplorer
Re: Problem after upgrading
Posted: 24 May 2025 11:33
by highend
I don't see a reason why it would switch back to some default config here...
Try this (while XY is NOT running):
Create a file `lic.ini` in your XY installation folder
Content:
Code: Select all
[Register]
Name=your (new?) registered name, fill it!
Code=your new key, fill it!
Now copy over your old settings again and run XY
It should be registered and using your old config data...