Custom Copy problems (CC)
Posted: 12 Dec 2022 20:28
Custom Copy problems (CC)
1.
Started CCopy and then attempted to stop and cancel it because I have forgotten if hidden folders would be a problem. Nothing appeared to happen. Later found the CC reply under other screens when it should have been on top.
2.
If the CC crashes will everything have to be copied again or will it treat the CC restart as a one-way sync for this external drive.
3.
Noticed that the CC screen did not show that W9 was being copied – in place of just D:
4.
This is a brand-new external 5TB drive. Notice ONLY nothing exists except a few folders by Seagate and then the W9 and subfolders.
5.
Noticed that the remaining time kept changing wildly. This could have been from M$. This prediction should, probably, be based on a moving average if the data is that choppy.
6.
This is all supposed to be a USB 3.0 or better. Any multi-hour operation should not stop unless with extreme reluctance and inability to continue. I would suggest an automated screen capture and then simply continue. As for speed and the 3.0 – I just can’t be bothered with who is at fault and how things should be if all hardware or software functioned as advertised. Getting things done is the goal. This can all be very important if a 1 or 2TB operation is to run overnight!
(THE SECOND JPG IS LIKELY TOO LARGE)
TG for XY.
1.
Started CCopy and then attempted to stop and cancel it because I have forgotten if hidden folders would be a problem. Nothing appeared to happen. Later found the CC reply under other screens when it should have been on top.
2.
If the CC crashes will everything have to be copied again or will it treat the CC restart as a one-way sync for this external drive.
3.
Noticed that the CC screen did not show that W9 was being copied – in place of just D:
4.
This is a brand-new external 5TB drive. Notice ONLY nothing exists except a few folders by Seagate and then the W9 and subfolders.
5.
Noticed that the remaining time kept changing wildly. This could have been from M$. This prediction should, probably, be based on a moving average if the data is that choppy.
6.
This is all supposed to be a USB 3.0 or better. Any multi-hour operation should not stop unless with extreme reluctance and inability to continue. I would suggest an automated screen capture and then simply continue. As for speed and the 3.0 – I just can’t be bothered with who is at fault and how things should be if all hardware or software functioned as advertised. Getting things done is the goal. This can all be very important if a 1 or 2TB operation is to run overnight!
(THE SECOND JPG IS LIKELY TOO LARGE)
TG for XY.