XYplorer Beta Club

after i press optimize tree key, i have to scroll tree a bit to see the optimized effect.

serendipity wrote:after i press optimize tree key, i have to scroll tree a bit to see the optimized effect.

My goal was to keep the current node visible. Is that not the case?

, it works fine now. what happened before was:
when i was in the lowest node in the tree and pressed "optimize tree" key the tree would show empty with scrollbar scrolled to the far down position. If I scrolled a bit higher i would see the tree again. but now i dont see it.
obviously there was something strange then and not now. hmmm will tell you if it happens again.

If you open the tree so that there is more than a screen's worth below drive C:, focus on C:\ and then optimize, nothing visually happens until you scroll the tree.

I just tried it as described by msalvatori, and for a bit, the entire tree was gone...like totally empty!

The scroll bar was still there so one could move tree back into (or out of!) view, but it seems that tree view isn't refreshing as it likely should...

j_c_hallgren wrote:I just tried it as described by msalvatori, and for a bit, the entire tree was gone...like totally empty!

Yeah, scary uh? I did nothing but trigger it, and I was left with blank area. Seems the Tree is collapsed but the scrollbar and its position aren't updated or something, cause I could scroll up for a bit before I saw my Tree again (BTW my current node was collapsed as well, is that the expected behavior? Wasn't for me, and reading "Only expand the current path, collapse all other paths." I tend to think it is not...)

Worse is, even my I expanded my current location, the scrollbar was still too big and allowed me to scroll down too much, and back to blank area!

Got it guys, fixed. Thanks!