Lost Names of Mapped Network Drives with v26.80.0000.

[admin]

Weird. I'll try some small things in the next beta. Shooting in the dark.

[AgentSmith007]

Ok, I decided to play with Network settings once again. After checking/unchecking each check box I was rebooting my main PC.
After I made these settings and rebooted my PC again XY showed mapped network drives like v26.70.0600 did. I rebooted my PC six more times and every time XY showed mapped drives the same correct way.

Here are the settings:

NetworkSettings.jpg (53.03 KiB) Viewed 1444 times

Here is screenshot of the tree:

XY26.80.0205_Works_Correct.jpg (196.71 KiB) Viewed 1444 times

I will see tomorrow morning when I boot my main PC and all network PCs and laptops are off.

Almost forgot, mapped drive letters are located before labels!

[admin]

Good, and if you check Configuration | General | Safety Belts, Network | Network | Assume that mapped network drives are available, the only difference should be that
- all icons are the "available" icons
- any custom names (which you don't seem to have) will be replaced by the generic names (as shown in your screenshot)

[admin]

- any custom names (which you don't seem to have) will be replaced by the generic names (as shown in your screenshot)

Not anymore since v26.80.0206

[Soleh]

My names are missing and I am also missing information like size etc. since the update.

[admin]

This is partly fixed in the current beta, and partly due to new settings. Untick these to get back to the previous ways:

Configuration | General | Safety Belts, Network | Network | Assume that mapped network drives are available
Configuration | General | Safety Belts, Network | Network | Skip calculation of free disk space for mapped network drives