Hi'
First, thank you all for your feedback!
---------------------------
autocart wrote:would be nice if it saved and reloaded the state of the current visual filter
Hmmm, it should already be working: AFAIK, filtering state is saved by default with the tabsets, then optionally with FolderViewSettings.
Here I have a "Video" session with its main tab filtered by "posters" only with
"|{:Image}", it's working fine. I also tried with a fresh install and it's working too…
It must be related to an XYplorer config setting/tweak; could you be more specific on how to reproduce?
---------------------------
yusef88 wrote:show sessions at the top of menu
This need may not be widespread enough to justify an option (unless you're keyboard-driven only?)… So here's a quick how-to:
Look for the
"Main Menu" section, and near the end of it,
cut the following lines:
Code: Select all
$Menu = $Menu.$MEN_l_sessions;
$Menu = $Menu."-"<crlf 2>;
[/size]
then paste them near the top of it, just before
"if $PRE_CurSess { // if session active", to get something like that:
Code: Select all
$Menu = $Menu.$MEN_l_sessions;
$Menu = $Menu."-"<crlf 2>;
if $PRE_CurSess { // if session active
[/size]
---------------------------
yusef88 wrote:i need that menu simple how to remove this text form it
? Weird wish !
Anyway, here's the how-to:
Look for the
"_Save" section, and near the top of it, remove the 4 lines in the middle
(and opt. the first ending <crlf>) of this block:
Code: Select all
$InpSess = input("Save & Use session$d_Save1", "<crlf>
Enter the name of the tabsets session to save. <crlf>
This session will be in use after you press OK. <crlf 2>
• The name has to be a valid filename, and can not contain '[' or ']'. <crlf 2>
$d_Save2
", , , "§CANCEL§");
[/size]to get that:
Code: Select all
$InpSess = input("Save & Use session$d_Save1", "
", , , "§CANCEL§");
[/size]Now, just out of curiosity, what's bothering you so much with it? It's not something you see very often and the editable field is auto-selected anyway...
Have a nice day,
Flux